11-15-2010 02:38 AM - edited 02-21-2020 04:58 PM
Hello!
A partner of CIsco from Singapore is asking if this would be possible on Cisco Anyconnect Secure Mobility
If I wish to use the "Cisco AnyConnect Secure Mobility" in the Anyconnect 3.0, can i configure that the user is not able to access any traffic via its wireless card when the VPN is established via the wired LAN port. i want to prevent any bridging between these two network ports when the VPN is up.
In addition, can I enable split tunneling so that all traffic needs to go thru the VPN tunneling?
Regards!
Ice Flancia
Cisco Partner Helpline Tier 2 Escalations Team
Solved! Go to Solution.
11-15-2010 02:46 AM
To route all traffic towards the VPN tunnel, split tunnel needs to be disabled (not enabled).
Under the group policy configuration: split-tunnel-policy tunnelall
Once split tunnel is disabled, the VPN users won't be able to access any of his/her local LAN networks anymore (including the wireless network).
Hope that helps.
11-15-2010 02:46 AM
To route all traffic towards the VPN tunnel, split tunnel needs to be disabled (not enabled).
Under the group policy configuration: split-tunnel-policy tunnelall
Once split tunnel is disabled, the VPN users won't be able to access any of his/her local LAN networks anymore (including the wireless network).
Hope that helps.
11-15-2010 03:05 AM
Thanks!! Appreciate your quick response!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide