03-18-2007 06:46 AM - edited 02-21-2020 02:55 PM
I am trying to setup a pix 506e and billion router site to site ipsec vpn.
currently it will not connect i have included the output from the syslog server and the pix config.
the seting on the billion are
ESP,SHA1,3DES
thanks
Alex
03-18-2007 07:25 AM
Please post the debug outputs for :
debug cry isa
debug cry ipsec
Also, try disabling pfs on both the devivces. And, correct the crypto ACL as "deny" statements are not supported in crypto ACL. Make sure it matches on both the ends.
*Please rate if helped.
-Kanishka
03-19-2007 01:02 AM
Hi,
As per the logs, it seems that there is a device between the PIX and the router that is blocking the traffic from the PIX to the router.
Please look into it.
HTH,
Regards,
Please rate if helps,
Kamal
11-03-2007 08:29 AM
11-03-2007 08:39 AM
Hey, I managed to get the tunnel working but it was never stable enough and I ended up using another pix. You might have more luck with the newer pix ios cause I was using 6.3 i think
Alex
11-04-2007 01:16 AM
Thanks Alex.
What vpn settings did you choose? Do you think you could send me your config settings for your pix and billion.
Thanks,
Rod
11-04-2007 05:36 AM
Ill have a dig around on my work computer. Have you asked billion they have a good support team for cross-vendor setups
Alex
11-05-2007 09:20 PM
Hi Alex, that would be great if you could send it. Thanks.
Billion are yet to respond.
11-06-2007 03:59 AM
Hey, are you UK based. I think i might have the VPN tech number for the UK.
Alex
11-06-2007 05:08 PM
Hey Alex, no i'm in Australia.
11-07-2007 02:15 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide