I am trying to install anyconnect 4.4 in my customer premises. The customer has some mapped drives in his PC ( windows 7), which is being affected after the anyconnect install. Once I install anyconnect, the mapped drive comes with a cross mark and the user has to click on the mapped drive to make sure it start working again .
What I can understand from the windows boot up process is that , the mapped drives comes up when the windows boots up. When the anyconnect comes up after the Windows boot process, the anyconnect flush the network connection, which makes the mapped drives come with a cross mark.
I have installed NAM,VPN & posture modules. I am not doing any authentication, this issue is happening when I just install anyconnect in the PC. My intention to provide network access upon successful authentication
As mentioned before, the issue is the cross mark, Once the user double click on the cross mark, everything goes fine. The user is annoyed, as the issue is happening with the restart of the PC