I have a IPsec tunnel between Site A and Site B. I have applied policy based routing to send all traffic of 188.8.131.52 to site B.
On site B, I want to use NAT to forward traffic of 192.168.10.100 received from tunnel to internet.
Remaining all users of subnet 192.168.10.0 are using internet from site A where as only 192.168.10.100 has to go to SITE B via tunnel and then use internet of Site B. The tunnel between SITE A and SITE B is established via tunnel.
interface GigabitEthernet0/1/0 ip address 184.108.40.206 255.255.255.252 load-interval 30 negotiation auto crypto map GCX_MAP end
we need to know the following configuration what is the content of GCX_MAP
or use below example - split-tunnel (remove IP address from that list) so that will use full cone of IPSEC running for Corporate and Internet traffic, (make sure if you have a proxy in your environment, may have side effects)
Site to Site IPSec VPN with Dynamic IP Endpoint is typically used when we have a branch sites which obtains a dynamic public IP from the Internet ISP. For example an ADSL connection.One important note is that Site-to-Site VPN with Dynamic remote routers P...
On R1, configure a key ring that defines the peer R3:Address: 220.127.116.11Local and remote pre-shared key: cisco R1(config)#crypto ikev2 keyring KRR1(config-ikev2-keyring)# peer R3R1(config-ikev2-keyring-peer)# address 18.104.22.168R1(config-ikev2-keyring-pee...
This document shows how to use the Port Radius NAS PORT Id Attribute in a compound condition to control access with 802.1X.A user jdoe is allowed to access the network only through the physical port FastEthernet 0/1 of the switch and the user jwhite is al...
This document provides a configuration example of Security Assertion Markup Language (SAML) Authentication on FTD managed over FDM. The configuration allows Anyconnect users to establish a VPN session authenticating with a SAML Identity Serv...
DMVPN Dual Hub Dual Cloud Pros and ConsProsNo single point of failureQuick failover if routing protocols are tunedLoad balancing is easyTraffic engineering is easyEasy to work with multiple ISPsConsNeed 2 tunnels per spokeConfiguration is more complicated...