10-14-2012 08:55 PM
For a remote vpn user who just want to access the internet for now. now I know you have to put the following in config when using ASA, what is the equivalent in IOS?
nat (outside,outside) dynamic interface.
thanks,
Han
Solved! Go to Solution.
10-15-2012 12:04 PM
10-14-2012 10:46 PM
Hello.
I think you wanted to achieve hairpinning for the ipsec remote access vpn users to access internet via vpn router..There is no direct way of doing this like we have in ASA.
Please follow the below cisco document where you can make use of nat on a stick configuration to achieve.. this
Regards
Harish
Please rate helpful posts!
10-15-2012 10:00 AM
Harish,
thanks first, however, i do have a question regarding the next-hop
route-map VPN-Client permit 10 match ip address 144 set ip next-hop 10.11.0.2
what is 10.11.0.2?
thanks,
Han
10-15-2012 10:33 AM
Hello ,
This is just an IP under loopback interface,
When traffic comes in through outside interface, it has to go through an inside & outside Nat in order to access internet,so what we are doing is to forcefully send the the traffic to loopback ( where we have ip nat inside configured - and it will undergo nat inside process) once it comes back to routing table then it will check the default route to go outside, ( this time nat outside process and we are good)..
Please shoot if you have any query.
regards
Harish.
Please rate all helpful posts!
10-15-2012 10:44 AM
So, it is a typo, not 10.11.0.2. isn't it?
it should be like,
set ip next-hop 10.11.0.1 since the lookback is 10.11.0.1
shouldnt it?
thanks,
Han
10-15-2012 10:51 AM
Hello Han,
No it is not a typo.. since the next hop ip is belongs to loopback interface, the route map will send the traffic to loopback interface ( that is ultimately we wanted router to do to imitate the inside interface.
the problem is ' for a nat to happen, the traffic has to go throug an inside and outside interface', so we are just faking the inside interface with the help of loopback !
regards
Harish
10-15-2012 11:44 AM
So, you mean it sends to an ip address that is not configured in the network but belongs to the subnet of the Loopback's.
So that the traffic is "tricked" to the loop interface?
thanks,
Han
10-15-2012 12:04 PM
Hello Han,
you are correct.!
Harish.
10-15-2012 05:40 AM
nat (outside) 1 192.168.237.0 255.255.255.0
global (outside) 1 interface
Assuming 192.168.237.0 255.255.255.0 is the ip pool assigned to the RA vpn
10-15-2012 05:49 AM
On IOS, you will need to create a pool for the dynamic interface using "ip nat pool" command then use "ip nat outside pool
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide