New PRI Install and Setup

[mjgoodman]

I've got 8 BRI lines I'm getting rid of and replacing with a PRI. I need assistance with coming up with a config that will allow home users with ISDN (BRI) to connect from home. I want to create a hunt group as well so the roll-over works for available channels. The T1 module is a NM-1CT1-CSU that will go into a 3620. The line is strictly incoming data connections.

Any useful links would be greatly appreciated as I am having a hard time finding them. This is also my first time setting this up.

[makchitale]

Need to use only the ISDN part from the below configuration:

http://www.cisco.com/en/US/products/hw/routers/ps274/products_configuration_example09186a0080094691.shtml

The calls will roll over to the next available B-channel, the hunt group will be done by the telco.

Thanks, Mak