01-22-2007 05:39 PM
Hi,
Could someone please provide a link describing how to configure the 3700 router with the WIC-1AM-V2 modem module.
The purpose of this is to access the Cisco 3700 CLI for management and troubleshoot via PSTN from a home PC with a dial-up modem incase the primary link goes down.
Thanks
01-22-2007 09:56 PM
Hi ,
The following link may help you.
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis2600/sw_conf/firmware/atwicbk/
Thanks
satish
01-22-2007 10:26 PM
Thanks Satish.
I would need more info on this. Its to do with setting up the interface async.
03-12-2007 03:59 PM
Hi,
Did you ever get a solution for this? I've look everywhere I can think of.
I'm trying to get one of these WIC modems to work in a 2811 router. All I want to test is dial in for out of band management.
Thanks
03-14-2007 12:28 PM
I got this to work for me.
After installation the config picked it up in this slot:
!
interface Async0/2/0
no ip address
encapsulation slip
!
So I appplied this and now I can dial into it and sustain a connection just fine:
line 0/2/0
modem InOut
transport input all
autoselect arap
stopbits 1
speed 115200
flowcontrol hardware
Late but maybe it will help someone else.
mlc
05-04-2009 02:17 PM
I get connected but get no response back.
Not sure what is wrong.
Here is my config
interface Async0/1/0
no ip address
encapsulation slip
line 0/1/0
no exec-banner
session-limit 10
modem InOut
no exec
transport input all
autoselect arap
stopbits 1
speed 115200
flowcontrol hardware
Please let me know if you have any suggestions. I am just using HyperTerminal to connect.
12-06-2012 01:07 PM
Hi Jsdeprey,
Not sure if you have got this resolved, but I ran into same issue. All you need is to configure password on
line 0/1/0.
It worked for me.
12-06-2012 01:45 PM
Yes I did get this working, thank for response.
I think I put a password there also, and it did not seem to really do anything but make it work, I think I even entered a bunk password there and it just started working. I found this fix from looking at a co workers config in another device I think.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide