Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Im trying to upgrade a 6509E with Sup2T from 15.1-2.SY7 to 15.1-2.SY9, and I can't get it to pull SY9 on boot?
Here is the boot disk, bootvar, and boot sys
WA-COR-DSW1A#sh bootdisk:-#- --length-- -----date/time------ path1 33554432 Jun 1 2016 16:...
Hi,I'm getting ready to setup one of our remote sites with wireless access of data only, no voice or customer access. Looks like H-REAP is the solution. Attached is a diagram of one of our remote site's connectivity and actual vlans. The following ...
Hi all,I've been reading through this support community for about a week now and found many discussions similar to my question about using fa/0 & fa/1 on my 2811's. Attached is a drawing of our typical remote locations. Left side is current configu...
HI,Looking for some opinions, advice or best practices on our remote office LAN configurations. We have 16 basically identical sites. Within the last year we have started deploying VoIP at these locations by adding them to our Call Manager, and soo...
Hi,I need to power down, move, and bring back on line a 6509 with one sup720. Other than making sure the config is saved, is there anything else (bootup related) that I should be aware of or perform before the move show ver shows his switch has bee...
I read through the Field Notice before and opened a case with TAC. Long story short, if the 79xx phone is under warranty or SmartNet you can get it replaced. If it is not covered then your basically out of luck unless you can convince your Cisco Re...
Hi,So I also just recieved 80+ 3600I access points pre-loaded as Mesh even though I responed "No" when my Cisco Partner asked. I need to convert them to local and finally FlexConnect. My WLC is 7.2.103 with NCS 1.1 In the past 2 months I've deploy...
HI,So I'm planning to upgrade a standalone 5508 from 7.0.98 to 7.0.220, which I've already downloaded from cisco.com. The current Field Recovery Image or ER.aes? is 6.0.182. I didn't see any ER.aes images to download. The release notes for 7.0.220 ...
