I have a packet capture on a Cisco 891 router configured with the following settings. It does not capture any packets. Anyone see what I have incorrect?
IP of the Hub or Head End side 66.179.xx.xx
IP of the 891 or spoke side 187.144.33.144
I apply the following to the spoke router.
ip access-list extended BUF-FILTER1234
permit ip host 66.179.xx.xx host 187.144.33.144
permit ip host 187.144.33.144 host 66.179.xx.xx
monitor capture buffer BUF1234 size 2048 max-size 1518 linear
monitor capture buffer BUF1234 filter access-list BUF-FILTER1234
monitor capture point ip cef POINT1234 dialer2 both
monitor capture point associate POINT1234 BUF1234
I then start the capture:
monitor capture point start POINT1234
2055951: Aug 26 22:45:51.327 UTC: %BUFCAP-6-ENABLE: Capture Point POINT1234 enabled.
Store_85000#
Wait a length of time and look at the dump and nothing.
Store_85000#show monitor capture buffer BUF1234 dump
Store_85000#
