PIX VPN config - Client welcome message possible?

[kkudlacek]

Hello all,

I recently configured a small PIX 506 firewall to terminate internet based remote on-demand client VPN connections (we are using the Cisco windows PC client software) and all is working well. Hovever, my customer would like to see a login welcome message like one would expect when connecting a VPN client to a VPN3000 box.

Any ideas if this is possible? How?

Thanks!

-Kale

[umedryk]

Check out configuring banners on pix at http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a0080172797.html

[shaun.oliver]

The banners mentioned in the above post are only for CLI (console, ssh, etc) logins, not for VPN clients.

[kkudlacek]

Exactly... the message we want will go to the VPN client after the client successfully connects to the PIX/VPN concentrator.

-Kale

[pauloroque]

Hi Kale,

I am having the same necessity. Have you found a solution?

Paulo Roque

[kkudlacek]

Paulo,

I haven't found a solution. I don't think it is possible with the PIX. We continue to run without the welcome messages.

-Kale