08-23-2007 03:37 AM
hello,
i have install a router 7200 with a serial and E1 interfaces.
i configure the dialer interface as a backup of serial interface, but whene i shutdown the serial the dialer stay in standby mode.
can any one help me pleaz
08-23-2007 08:08 AM
imane
Before you posted this question in this forum you posted the same question in the WAN Routing and Switching forum and it has received a couple of responses in the WAN forum. I suggest that any further discussion of this question be consolidated in the WAN forum.
HTH
Rick
08-23-2007 08:52 AM
Hi
What interface do you have you back up interface under ? as once you use the back up interface that interface will always be in standby mode.
I guess a better question is it is not dialing when the orimary interface is down ? thus not comming out of standby ?
Thx Steve
08-23-2007 09:01 AM
Steve
The original post is pretty clear that he is doing a shutdown on the primary interface and expecting the backup to come out of standby status. It is clearly the behavior of IOS that it will NOT come out of standby if the primary is shutdown. It will only come out of standby if the primary goes protocol down (and not come out of standby for administratively down).
HTH
Rick
08-23-2007 09:23 PM
Hi ,
Can you paste the config of the 7200 ..
Thanks,
satish
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide