05-08-2012 10:58 PM - edited 02-21-2020 06:03 PM
Hi all
I have created remote access vpn in my ASA 5505. The tunnel is established but i am not able to access the internal network.
please help
Regards,
Ejaz
05-08-2012 11:37 PM
Hi Ejaz
Is this a new VPN tunnel that you have created?
If so remember that you still need to allow the traffic for that VPN DHCP pool in the inside interface so you can access the internal Network.
In case you allow just please paste the configuration here so I can have a look. Please make sure to remove sensitive information.
You can also use packet tracer to give a better idea where is dropping the traffic.
ciscoasa(config)#packet-tracer input outside icmp "source ip" "destination ip" detailed
Regards
Sent from Cisco Technical Support iPad App
05-09-2012 02:03 AM
Hi Vieira,
Thank you for the response. Please check your private message.
Regards,
Ejaz
05-09-2012 08:47 AM
Don't have any personal messages
Sent from Cisco Technical Support iPad App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide