VPN

Hi,The  router is performing PAT  for internet access and I'm trying to enable it as an EZVPN server Using  the Cisco VPN client, I'm able to connect it and bring up the tunnel. i  can pass traffic by vpn and can ping the local server but can't acces...

Hello,I have aproblem installing the posture module of AnyConnect VPN Client. During the installation I get an error: "Product: Cisco AnyConnect Posture Module -- Error 1335. The cabinet file 'disk1.cab' required for this installation is corrupt and ...

I recently set up an ASA 5505 with AnyConnect.  Its a very simple set up.  I have the ASA 5505  (E0/0) that is plugged straight to the ISP private static IP address. I have a computer connect to the console port for configurations.  I also have 1 lap...

Have an ASA 5520 running 8.2(2) and we have been experiencing problems with our Clientless VPN over the last month.  Users can connect to the VPN and get all the bookmarks displayed.  When they click on the bookmarks we use smart-tunnel: ACL's to ope...

I would like to ask your help solving a VPN issue with the device on the far end.I have one established IPSec tunnel between the host at the far end. When they try to eatablise a second IPSec tunnel to our seconf IP we get this errorMay  9 18:51:51 o...

hi Guys,I have vpn configured on ASA (6.2(3) , the user complain they get connected but get disconnected (not while in idle) frequently like after may be 5 min / 10 min .Is there any factor tat  to be looked into for the timeout value.And they have a...

Dear all,I have configured ASA as a client for LDAP authentication when remote access vpn is in use.Almost everything works fine. I mean, I can login to network, I can get some attributes located in LDAP, etc.But I have met problem.When login name is...

I am trying to access a cisco vpn site with my computer running linux (fedora 16).  If I go the the vpn gateway site I can either run the AnyConnect client 2.5  software from online or download and install it.  After I try to connect to the gateway I...

HiI have just bought a SA520.Seems like a great box Have now set up some SSL tunnels, and it works great.Only problem I see is that users can change password, and if they want they can set password to anything they like.Is there any way of restrictin...

Hi, I'm trying to configure a VPN between a Check Point firewall (UTM-1, running R75.10) and a 2921 router (15.0(1r)M9).Here's the relevant config (names and external IP addresses only modified - using 1.1.1.1 for Check Point and 2.2.2.2 for Cisco):=...

Hi.I am terminating GRE vrf-lite on my 7600 and using loopback as source for each client.I found one problem where 7600 seems to be not forwarding traffic until I delete create the tunnel interface.Worked fine for a week. Then stopped again. I had to...

Ok, this behavior is new to me.  It would appear to have considerable security implications as well.  Comments are welcome!My ASA (5520, 8.2(5)) terminates both L2L and Remote (User/RAS) IPSEC VPNs.  Each L2L VPN has a crypto map sequence, and I have...

Hi Team,I have the following set up on my ASA 5510 ( 8.4)e0/0 - Outside - leased internet line with static IPe 0/1 - Insidee 0/2 - DSL -  ADSL PPPoE line with Dynamic IPI have site - site VPN set on the leased line Internet traffic being routed over ...