SA-VAM not supported in Cisco 7206VXR

[Anand Thakur]

Hi,

I have a Cisco 7206VXR with NPE-400. The IOS version is 12.4(24)T3. I installed a SA-VAM in the router in slot 6 but getting the following on the console.

AP-Pune-RT#
Feb 23 11:16:34.484: %PA-3-NOTSUPPORTED: PA in slot6 (Unknown (type 650)) is not
supported on this chassis
Feb 23 11:16:34.484: %PA-3-DEACTIVATED: port adapter in bay [6] powered off.
Feb 23 11:16:34.584: %PA-2-PABRIDGE: Failed to config bridge for PA 6
Feb 23 11:16:35.384: %PA-4-IMPROPER_REMOVAL: Improper removal for slot 6.
Feb 23 11:16:35.384: %PA-3-DEACTIVATED: port adapter in bay [6] powered off.
Feb 23 11:16:35.468: %CRYPTO-4-PKT_REPLAY_ERR: decrypt: replay check failed
        connection id=975, sequence number=677864

Is the SA-VAM not supported in the Router 7206VXR?

Thanks in advance.

Regards,

Anand

[Yudong Wu · Accepted solution]

It should be supported.

Maybe the lastest IOS stop supporting this EoS card.

You can try to downgrade your IOS to 12.3T or 12.2T to see if it makes any diff.

[Herbert Baerten · Accepted solution]

VAM and VAM2 are only supported until 12.4(15)T (and rebuilds, so including 12.4(15)T1, T2 etc.).

So you would either have to downgrade the IOS, or replace the VAM with a VAM2+.

cfr http://www.cisco.com/en/US/prod/collateral/modules/ps8768/ps5308/prod_end-of-life_notice0900aecd8033791f.html

hth

Herbert

[Anand Thakur]

Hi Guys,

I downgraded the IOS of the router to c7200-jk9o3s-mz.123-26.bin and the VAM card is now working fine.

Great thanks to you guys for the guidance.

Regards,

Anand