Buy or Renew
Buy or Renew

VPN

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Cisco CyberSecurity
Labels

Forum Posts

Start a conversation

ASA Site to site VPN

Hi... I have created a site to site VPN between my office in INDIA and my client's office in BAHRIN... In Bahrin's office have 2 network.. i have created ACEs for both these two network.. everything is fine.. but in some occasion we can reach only to...

vipinrajrc by • Level 3
  • 2013 Views
  • 17 replies
  • 0 Helpful votes

Resolved! Forwarded port , conflict with VPN

Hello,I have some WEB SERVER that I would like to share , this bellow port forwarding work well :I mean by this :The WEB SERVER is 192.168.10.10 on the LAN , and on the WEB it is 81.83.XX.YY:8095When I try this it works , with VPN ON or OFF.If I make...

Didier1966 by • Level 1
  • 1133 Views
  • 11 replies
  • 0 Helpful votes

Cisco ASA 5500 and Cisco ISR 881W

Hello all,is it possible to setup a Cisco ISR 881W so it connects to a Cisco ASA 5500 series head via network extension mode? We did this in the past with our PIX connecting to 3000 series concentrator.thank you in advance,GMF

User name in site-to-site vpn?

It's been several years since I set up non-DMVPN  IPSEC VPNs.  At the time it was Pix 515s.  If I remember correctly, I could set up either a site-to-site vpn (in which phase I and phase II specs were entered, PSK, etc.) of a remote-user vpn (where t...

Replacing VPN router with cisco ASA 5510

Hi Guys,I got a task to replace our current cisco 2800 series router which is used for easy vpn remote access with cisco asa 5510.I have a got a lot of users, i wish that user shall see no difference except of ip address they are going to use for rem...

Resolved! Differences and Similarities between standard VPN client and AnyConnect Client

I have experience using the Cisco VPN client and configuring the ASA appliances with Crypto Maps and such to help establish what I would consider "normal VPN" tunnels.I (my company is a Cisco Channel Partner) am meeting with a perspective client tomo...

ASA 7.2(4) VPN with NAT Question

I have a question about ASA NAT capabilities (please see attached network diagram). Hope someone can help me!Scenario 1:- Clients on Site B want to access Resources on Site A- Traffic is translated on Site B, to be sourced from a different IP (permit...

i.va by • Level 3
  • 401 Views
  • 2 replies
  • 0 Helpful votes

Resolved! SA-VAM not supported in Cisco 7206VXR

Hi,I have a Cisco 7206VXR with NPE-400. The IOS version is 12.4(24)T3. I installed a SA-VAM in the router in slot 6 but getting the following on the console.AP-Pune-RT#Feb 23 11:16:34.484: %PA-3-NOTSUPPORTED: PA in slot6 (Unknown (type 650)) is not s...

Resolved! Problem to access https after upgrade 8.4

Hi, i try to upgrde a new device with no config inside... I put the asa and asdm file in the device (last release), then i simply remove the old asa and the old asdm.No the https:192.168.1.1 is no longer accessible.There is my config : Wats wrong ?AS...

supportttt by • Level 1
  • 6719 Views
  • 17 replies
  • 0 Helpful votes

Resolved! DMVPN Phases

I'm a bit confused now, because i have realized that i can't understand DMVPN phases.Can somebody explain me - what is the difference between Hub-and-Spoke Network and Full-Meshed Network.1) Hub-and-Spoke Network - all DMVPN traffic goes through HUB....

Load more