Rob,
When I run the "debug crypto isakmp" it simply says "Crypto ISAKMP debugging is on" and when I run the various "show" commands all the results show zero activity.
----------------------
VTARouter#
VTARouter#show crypto isakmp sa
IPv4 Crypto ISAKMP SA
dst src state conn-id status
20.20.20.2 10.10.10.2 MM_NO_STATE 0 ACTIVE
IPv6 Crypto ISAKMP SA
VTARouter#debug crypto isakmp
Crypto ISAKMP debugging is on
VTARouter#
VTARouter#
VTARouter#show crypto map
Crypto Map IPv4 "mymap" 10 ipsec-isakmp
Peer = 20.20.20.2
Extended IP access list brvpn
access-list brvpn permit ip 192.168.0.0 0.0.0.255 192.168.3.0 0.0.0.255
Current peer: 20.20.20.2
Security association lifetime: 4608000 kilobytes/3600 seconds
Responder-Only (Y/N): N
PFS (Y/N): N
Mixed-mode : Disabled
Transform sets={
myset: { esp-aes esp-sha256-hmac } ,
}
Interfaces using crypto map mymap:
GigabitEthernet0/0/1
VTARouter#show crypto ipsec sa
interface: GigabitEthernet0/0/1
Crypto map tag: mymap, local addr 10.10.10.2
protected vrf: (none)
local ident (addr/mask/prot/port): (192.168.0.0/255.255.255.0/0/0)
remote ident (addr/mask/prot/port): (192.168.3.0/255.255.255.0/0/0)
current_peer 20.20.20.2 port 500
PERMIT, flags={origin_is_acl,}
#pkts encaps: 0, #pkts encrypt: 0, #pkts digest: 0
#pkts decaps: 0, #pkts decrypt: 0, #pkts verify: 0
#pkts compressed: 0, #pkts decompressed: 0
#pkts not compressed: 0, #pkts compr. failed: 0
#pkts not decompressed: 0, #pkts decompress failed: 0
#send errors 48, #recv errors 0
local crypto endpt.: 10.10.10.2, remote crypto endpt.: 20.20.20.2
plaintext mtu 1500, path mtu 1500, ip mtu 1500, ip mtu idb GigabitEthernet0/0/1
current outbound spi: 0x0(0)
PFS (Y/N): N, DH group: none
inbound esp sas:
inbound ah sas:
inbound pcp sas:
outbound esp sas:
outbound ah sas:
outbound pcp sas:
VTARouter#
