11-20-2012 02:13 PM
Hi All,
I've configured SSL VPN (Full Tunnel) on a Cisco 1941 router. The SSLVPN license is activated and enabled. Also the StartSSL certificate is installed successfully. I believe..
The login webpage appears and users can login but the SSL VPN client download fails with this message "The installler was not able to start the Cisco SSL VPN Client."
Please find my router config as attachment.
Please let me know how I can fix this.
Note:
Router External IP: 31.XX.XX.50
IP used as SSLVPN Gateway: 31.XX.XX.51
The SSL VPN client was already on the flash of the router, so I used it.
Do I need to install the anyconnect vpn client or vpn client 5.x version. But I can not find any .pkg versions, only found .exe versions?
Regards,
Kuldeep Saxena
11-20-2012 02:44 PM
Hi Kuldeep,
Please make the following change:
policy group policy_1
no functions svc-required
Let me know.
Please rate any helpful posts
11-20-2012 02:51 PM
Hi there,
I initially had the configs without this line and was receiving every same error.
I added "functions svc-required" in hope it will automate the download. But you know the rest!!
Regards.
Kuldeep
11-20-2012 07:41 PM
Please enable the following command and then try to connect:
ip inspect log drop-pkt
If I am not overlooking at the configuration, it seems to be ok, so I would like to check ZBF.
Please check the logs generated by the Router and let me know if you see anything related to your connection.
Thanks.
Portu.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide