We currently have a VPN setup for our users when they are on the road or working from home using Cisco AnyConnect. We have the VPN setup on our ASA 5508 Firewall.
I now have a client that we send data to that needs us to setup a VPN for the connection. I was wondering if there was anyone out there that would be able to help me create the VPN (IKEv1 or IKEv2) and fill out this VPN questionnaire. Thank you in advance!!
Solved! Go to Solution.
If you saved the configuration it should save the full configuration.
Perform a test (out of hours) make a change, save the configuration and reboot. If the settings are lost then you could potentially have a hardware/software issue, in which case you'd have to log a call with TAC.
Before testing, take a full backup of the ASA.
Not sure if @Rob Ingram jumped into this already, if not, what specifically you think has been wiped out after the firewall reload? typically, if you save the config it should remain there, unless your device has a corrupted filesystem that does not allow storing the running config to the startup config. One easy way to verify this is to save, and then issuing the command show startup-config and check if the new changes are reflecting in there.
Thank you! Everything looks good when I run show startup-config, however, I did see a line that needs to be updated. Where would I update the email address in the line below? The user who's email is listed is no longer with the company. Thansk!
logging recipient-address firstname.lastname@example.org level alerts