What are the commands to change the VPN peer IP address from Cisco CLI

[ESTE]

Need commands step by step to make changes.

[Dennis Mink]

amigo,

do a sh run and verify, your crypto peer address and change that by going into config mode. If you are not familiar with configuration mode, look up the cli guide

[ESTE]

I know the crypto peer address and what to change it to. I need the command steps.

[Dennis Mink]

#conf t

# no <statement with old address>

#<statement with new address>

#exit

write mem

[Rob Ingram]

Hi,
What Cisco device are you referring to ASA or IOS Router? They are different commands
Also what type of VPN, crypto map or VTI? Again there is a difference for the CLI syntax

It would help if you could post your configuration

[ESTE]

IOS and crypto map.

[Rob Ingram · Accepted solution]

crypto map CRYPTO_MAP 1 ipsec-isakmp
no set peer x.x.x.x
set peer y.y.y.y

Change the name of the crypto map (CRYPTO_MAP) and sequence number (1) to the name of your crypto map and correct sequence number.

[ESTE]

This is helpful. Do I need to change the IP in another place also?

[Dennis Mink]

no only one place; the crypto map

[ESTE]

I changed the name and got the below output.

          CRYPTO_MAP IPV4 "vpn" 61 ipsec-isakmp
                       ^

[Deepak Kumar]

Hi,
Please share running configuration so we can suggest you better.

Regards,
Deepak Kumar

[ESTE]

I've made the changes. I also needed to change the crypto isakmp key.

Thank you for your help.

[Jaderson Pessoa]

Hello there,

Check this link: https://community.cisco.com/t5/vpn-and-anyconnect/change-peer-ip-of-remote-vpn/td-p/1959438
There is a good steps for you.

I hope that it can help you.

[Jaderson Pessoa]

Do not forget to mark as useful the whole post that helps you.

thanks in advance.