Desk Pro and Room Navigator

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-24-2021 06:30 AM
Is it possible to connect a Room Navigator to a Desk Pro? I have an executive that does not like to lean towards the camera to shut it off as they say it looks unprofessional and would like to do this with either a Touch 10( EOL) or Navigator.
- Labels:
-
Desktop Devices
-
Touch Controller

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-23-2024 10:17 PM
Yes, you can pair a Room Navigator with a Desk Pro using recent software, however, the camera privacy switch on the Desk Pro is a physical switch/slider - there is no way to operate this via a Room Navigator.
You can do all the other normal call control (dial / hang up / change volume / etc.) from the Navigator.
Please remember to mark helpful responses and to set your question as answered if appropriate.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-14-2024 10:12 AM
not out of the box, but using the APIs you could do device controls in a web interface and that could be displayed on a room navigator, iPad, PC, etc...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-27-2021 07:59 PM
Product compatibility |
Webex Room Kit Series, Webex Room55 and Room70 Series, Webex Room Panorama, Webex Board 55S, 70S, 85S |
