01-12-2020 06:14 AM - edited 07-05-2021 11:31 AM
Hi Folks,
In the past when working with WLCs the interfaces have always been configured as LAG / trunk with the dynamic interfaces/vlans all going through the same LAG.
Can I have say some ports configured in a lag and then the left over physical ports potentially used for a specific dynamic interface? E.G for a dmz
Solved! Go to Solution.
01-12-2020 12:11 PM
01-12-2020 07:36 AM - edited 01-12-2020 07:36 AM
I take that as a separate segment, not you looking in exiting LAG, then you should be able to.
But again it depends on the use case.
01-12-2020 07:54 AM
01-12-2020 08:03 AM
personally not implemented never come across this requirement, this is good requirement.
as long that VLAN untagged in LAG, Only Tagged other Port it should work.
here is the reference :
01-12-2020 10:10 AM
01-12-2020 11:20 AM
01-12-2020 12:11 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide