06-06-2019 06:48 PM - edited 07-05-2021 10:31 AM
Hi We cab get configuration by command "show run" via console connected to AP. Can we get the configuration via WLC? Thank you
06-06-2019 11:47 PM
Hi @wfqk
Run the command show ap config general <AP name> and see this helps for your requirement. If you want to get the specific Info of the AP, use the command grep include "Key word" "show ap config general <AP name>" (Double quotes are required and Key word should exactly same on the output)
You can refer this CLI command details Cisco WLC for all the possible show commands on the AP.
06-07-2019 07:04 AM
Thank you so much for your reply. In comparison with logging on to AP to get configuration, the command you mentioned cannot get more info, am I right?
06-07-2019 07:51 AM - edited 06-07-2019 07:52 AM
Yes, this command provide you the AP group , Native VLAN, Policy ACL's and etc details. Which you are performing through WLC.
06-09-2019 12:44 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide