02-21-2019 10:43 PM - edited 07-05-2021 09:55 AM
i am facing very strange issue with flexconnect, if i join a flexconnect ap to a remote wlc and configure the flexgroup settings, clients are unable to join and i cannot even see any hits on the remote wlc. even if i run a client debug on the remote wlc, i dont see a single hit.
but if i convert the same ap into local mode and do everything central , it works straightaway and i can see clients connected on the wlc , so far i have seen this behavior on code 8.2 and 8.5 and on multiple wlc platforms. the ap that i am using is a 2800 series ap.
is this a known issue ?
02-22-2019 06:20 AM
Hi,
Looks like in flexconnect mode the client is not associating to the network. Which authentication method do you have?
I guest this can be some configuration.
-If I helped you somehow, please, rate it as useful.-
02-24-2019 06:23 PM
Sounds like a config issue, is it working for any of the Flexconnect APs/ WLANs?
Can you share the following outputs:
Show wlan <WLAN ID>
show flexconnect group summary
show flexconnect group detail <Flexconnect Group Name>
Also share the switchport config of one of the Flexconnect APs
02-25-2019 10:35 PM
hi , the ssid has "local switching" enabled .
in the flex group , the mapping of wlan/vlan is defined correctly
also the switchport configuration looks like this
interface gx/x
switchport trunk encapsulation dot1q
switchport mode trunk
switchport trunk native vlan 102
switchport trunk allowed vlan 102, 1401
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide