Enabling PoE Out ports on AP

[TH09]

Hi there,

Can someone tell me how to enable poe out ports on a ap using wlc gui and cli commands?

When I try to run the (B1-WLC2) >config ap lan poe-out enable APRAP1 it throws the following:

Incorrect input! Use 'config ap lan poe-out <enable/disable> <AP-NAME>'

Lan Override .................................... Disabled
Port Status POE Power Level
------ -------- -------- ----------------
LAN1 DISABLED DISABLED None
LAN2 DISABLED DISABLED None

(B1-WLC2) >config ap lan poe-out enable APRAP1

Incorrect input! Use 'config ap lan poe-out <enable/disable> <AP-NAME>'

[Jaderson Pessoa]

Hello,

try it:

config ap power injector enable {Cisco_AP | all} override
You can use this command if your network does not contain any older Cisco 6-W switches that could be overloaded if connected directly to a 12-W access point. The access point assumes that a power injector is always connected. If you relocate the access point, it continues to assume that a power injector is present.
If you know the MAC address of the connected switch port and do not want to automatically detect it using the installed option, enter this command:
config ap power injector enable {Cisco_AP | all} switch_port_mac_address

Look here: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_01111111.html

[fengzh]

you can try CLI: (Cisco Controller) >config ap lan port-id 1 poe enable AP-NAME;

Or GUI Go to 'Port/Module' tab in that AP group and enable PoE on Lan 1 port