Interface in group out of DHCP address space

[JASON SIMMONS]

I have a 2 member interface group associated to a WLAN, interface 1 and interface 2.  I know the controller round-robins clients between the interfaces in the group when they connect to the WLAN.  If the controller assigns a client to interface 1 and the DHCP scope associated to that interface is out of available IP addresses, does the controller automatically move that client to interface 2?

[Flavio Miranda]

Hi,

 Yes  and the WLC will mark the interface 1 as durty, start a DirtyTime and avoid interface 1 during this counting down. 

After the timer expires it try again. 

 You can see this on the cli by issuing  "show inter group detail "name" "

-If I helped you somehow, please, rate it as useful.-

[Haydn Andrews]

Agree with Flavio