11-25-2015 05:22 AM - edited 07-05-2021 04:18 AM
hi ,,
accually this is my first time to work with Cisco wireless ,i have WLC 5508 and 5 AIR-CAP2702E-E-K9 and word file have PAK for the 5508
i do not know how to start ,the main qoustion is :
1- how to add this license to WLC 5508
2- how to connect AIR-CAP2702E-E-K9 to our WLC5508
Thanks
Solved! Go to Solution.
11-25-2015 06:30 AM
Hope this helps:
How to manage license:
http://www.cisco.com/en/US/docs/wireless/controller/7.4/configuration/guides/system_management/config_system_management_chapter_011.html#ID307
Connect AP's to the 5508, you need to understand the basics design and why an AP might not join the controller:
http://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/119286-lap-notjoin-wlc-tshoot.html
http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/70333-lap-registration.html
-Scott
11-25-2015 10:44 PM
11-25-2015 06:30 AM
Hope this helps:
How to manage license:
http://www.cisco.com/en/US/docs/wireless/controller/7.4/configuration/guides/system_management/config_system_management_chapter_011.html#ID307
Connect AP's to the 5508, you need to understand the basics design and why an AP might not join the controller:
http://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/119286-lap-notjoin-wlc-tshoot.html
http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/70333-lap-registration.html
-Scott
11-25-2015 06:32 AM
Easiest way is to make sure that the time is set properly on the contoller or else AP's will not join. Place the AP on the same subnet as the controller for an easy join. Once the AP joins and downloads the code and is in the run state, then you can move the AP to another vlan. Make sure that the AP gets an ip address also.
-Scott
11-26-2015 04:00 AM
Many Thanks to you Scott ,i follow the instruction one by one and i added successfully ,i will procced with adding Ap to WLC .
Thanks gain for help
11-26-2015 08:50 AM
Glad to help. If you run into issues, just reply to the post.
-Scott
12-08-2015 11:02 PM
HI Scot ,
I tried all ways to connect to WLC but i think the problem is in WLC version is not compatible with 2700 series ,the current version is 7.4.110.0 and based on mention article there is compatibility issue
http://www.cisco.com/c/en/us/td/docs/wireless/compatibility/matrix/compatibility-matrix.html
12-09-2015 06:16 AM
Yup... That compatibility matrix you should keep handy. Code versions is important to make sure that AP's connect and also you will see what code is supported on them.
-Scott
11-25-2015 10:44 PM
adding to scott..post...
How to add AP licenses to a Cisco 5508 WLAN controller
Lightweight AP (LAP) Registration to a Wireless LAN Controller (WLC)
Regards
11-26-2015 04:02 AM
Many thanks to you too ,clear steps
thanks for help
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide