Wireless

I have a 5508 series WLC running 8.0.135.0. I have noticed that the rogue APs do not show up in the GUI until you run #show rogue ap sum in the CLI. Then again to get an update you must run the CLI command. Has anyone noticed this?

Hi all  just small Question about MSE version 10 if i buy it as a virtual can i installed in hyper V or not ? and what is the specification for that ? thanks 

I HAVE 4 AIR-AP1825E-N-K9 and a wireless Controller 2504 but I can´t see them on the WLC? IS PROBLEM WITH THE FIRMWARE OF THE WLC?

I HAVE 4 AIR-AP1825E-N-K9 and a wireless Controller 2504 but I can´t see them on the WLC? IS PROBLEM WITH THE FIRMWARE OF THE WLC?

I HAVE 4 AIR-AP1825E-N-K9 and a wireless Controller 2504 but I can´t see them on the WLC? IS PROBLEM WITH THE FIRMWARE OF THE WLC?

I HAVE 4 AIR-AP1825E-N-K9 and a wireless Controller 2504 but I can´t see them on the WLC? IS PROBLEM WITH THE FIRMWARE OF THE WLC?

I HAVE 4 AIR-AP1825E-N-K9 and a wireless Controller 2504 but I can´t see them on the WLC? IS PROBLEM WITH THE FIRMWARE OF THE WLC?

Hi On a WLAN network for one of our customers we only allow APs to connect if they authorise against a AAA radius server using the mac address of the AP ethernet interface as the username and password. Currently we do this using an ACS as the AAA rad...

Hi, Facing issue while configuring 1830 AP in standalone mode. Already did hardware reset, still its searching for controller. Anyone help with the document or guide.

Hi, I have problem here regarding my cisco 1600 aironet AP. It always reboot itself with this command. All AP that connected on this WLC face same issue. My WLC now running 8.1.131.0 software version. The AP connected by using POE. Mon Jul 25 15:...

Hi all, I am getting a continuous stream of messages like the ones below on my 2504 WLC. *webauthRedirect: Jul 22 23:05:25.275: %EMWEB-6-PARSE_ERROR: webauth_redirect.c:1477 parser exited. client mac= 54:ef:92:37:e4:30 bytes parsed = 0 and bytes read...

Hi, Now, i am facing some time zone issues with ISE 2.1. When i create Self-Registered Guest Portal, i can add our time Zone (Yangon). Then i change to Sponsored Guest Portal with my authorization profile, this portal is using default time zone (San ...

Hi, Request your help with the part number for WLC-HA I am using two WLC (AIR-CT5508-50-K9), which is running as independent controllers in the same datacenter. One controller has been loaded with 75 AP Licenses and other with 50 AP Licences. And a t...

Hi all, I have an Aironet 1140, it has been running without problem for some time with a single SSID. I recently added a second SSID and both can be seen and used by PC's, however the second SSID cannot be seen by apple devices. I've tried iphones, i...

Hi all who can help me... i need to know what is the cisco LAp compliant with the more high atex directive ..someone can help me ?? thx all