Remove AP from flexConnect Groups!!

[saboodi]

Hello All,

I got issue when I removed APs and redeployment to another site! when I removed them I cleared everything inside the AP  and put new IP add and New IP add for new controller. but when install these APs onsite it will keep join to old WLC and I configured them with new IP add for new WLC. There is any method can remove these APs from old WLC before join them on site ??

Some my coworker they told me I cann't remove them from old WLC first I have attached them online after that I have to got to FlexConnect group and remove them 

[Rasika Nayanajith]

AP will remember previously registered WLC in its NVRAM. If it is not 18xx/28xx/38xx/48xx series AP you can clear those NVRAM configs like below.

LAP1#debug capwap console cli

LAP1#erase /all nvram:
Erasing the nvram filesystem will remove all files! Continue? [confirm]
[OK]
Erase of nvram: complete

HTH

Rasika

*** Pls rate all useful responses ***

[saboodi]

Hello Rasika,

Actually, I got APs 2602I. and there is no work needed to do on WLC site?

Thanks

[Rasika Nayanajith]

From WLC, you can "Clear All configs" in Wireless -> given AP General page. That should clear any configs 

However that will not forget AP previously learn WLCs in NVRAM.

HTH

Rasika