cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
174
Views
0
Helpful
1
Replies
Highlighted
Beginner

Why wlan using management interface?

Hi experts!
So i'm learning about my client's WLC, and had some difficulties to understand management interface in wlan.

Why is my client ssid/wlan (named 3cluster) is assigned with managament interface?
This ssid's dhcp is on our core switch interface vlan (int vlan 51), and on that interface vlan there is dhcp relay to my client's dhcp server.

Why don't the ssid/wlan 3cluster is assigned with the interface vlan 51?
Interface with vlan 51 has already in wlc's controller -> interface, but once again, not used by 3cluster ssid/wlan.

The client which is connected to 3cluster ssid has ip address and default gateway with same subnet with interface vlan 51 on core switch.

1 REPLY 1
Highlighted
VIP Mentor

Re: Why wlan using management interface?

I think your Management interface is in vlan 51 only.

 

Just paste the output the command:

 

show interface detailed management

sh run int <>   --> where wlc mgmt port connecte don swicth

 

Regards

Dont forget to rate helpful posts

CreatePlease to create content
Content for Community-Ad

Cisco COVID-19 Survey