Wireless controller with LDAP problem using iPhone (802.1x)
I have Cisco WLC running Software Version 22.214.171.124 .
I connect the WLC with my LDAP ( Windown Active Directory ) to use loacl EAP authentication ( 802.1x ) using PEAP method.
i fininsh the job and my windows clients ( PCs) is working properly and my Mobile runining android is working properly too , but our iphone clients can not join the network , i receive this message " Unable to join the network .... ".
i used iPhone configuration utility to create new profile to i sent it to iphone device but still i can't join.
by the way i'm using these protocols ( 802.1x , WPA Policy-AES , PEAP)
Just to add... you should upgrade to v126.96.36.199 and make sure you have FUS 188.8.131.52 also installed. As far as Apple iPhones, you should also be on the latest firmware 8.1.2. The configuration you need is 802.1x (WPA2/AES) not WPA/AES, so make sure that is set properly.
QuestionI have the following Air AP:Air-AP1562I-B-K9, 802.11ac outdoor access point There are three antenna cables that go from the inside cover to some soldered connections on a PCB. When removing the cover, two of the soldered antenna connections c...
QuestionHiWe have a guest access set up and was wondering what exactly are the sequence of events from connecting to SSID to being granted internet access, see below steps I'm unsure of are left blank1. connect o SSID through AP2. traffic hits Foreign WLC...
Model:C9120AXI-Q Install EWC on C9120 running with CAPWAP as shown in the attached log, but the installation fails.It looks like you're getting an error like out of storage space.Is there any good way?