download TFTPd32 from Google and install it on ur PC.. point the image that you have downloaded in the TFTP server..
connect a Ethernet cable between ur laptop and AP.. both should be in the same subnet.. and connect a console cable and get the hyperterminal console access and issue the command.. make sure you are able to ping the PC and the AP and vice versa!!
AP#debug lwapp console cli or debug capwap console cli
AP(confg)int fa 0
AP(confg-if)ip addr <addr> <mask> (same subnet as that of the laptop)
AP#archive download-sw /force-reload /overwrite tftp://<tftp ip address>/<image name.tar>
I am trying to setup a 1852 with Mobility Express. I can get it working with most items, however we have a Security Policy in place that says that management traffic should be segmented from other traffic. In a normal WLC situation all the APs are on vlan...
Hello,I have a Cisco 3702i setup in autonomous mode that has been running for a few weeks. I can SSH into it using my new username and password, but can't use this to log into the GUI I have to use the default of Cisco:Cisco, it seems to be the only...
Hello,I only did this a few weeks ago and it was easier, but today I can't reset another spare AP and set it to autonomous. I was originally connected to our WLC so I've consoled in and removed the config.txt and the private-multiple-fs anre reboote...
Hi All, I thought I was getting to grips with the wireless world but I am finding that I am a little out of my depth setting up a test Cisco Catalyst 9800-CL Wireless Controller. This will be my third controller, this one I am testing in a ...