06-01-2011 07:46 AM - edited 07-03-2021 08:16 PM
Hi,
Anyone can help me ?
How can we convert a Cisco AP from LWAPP to Autonomous mode ?
Regards
Solved! Go to Solution.
06-01-2011 07:49 AM
Hi,
Here is the doc that i hv written and this includes the video as well!! this will resolve the issue!!
https://supportforums.cisco.com/docs/DOC-14960
Please dont forget to rate the usefull posts!!
Regards
Surendra
06-01-2011 07:50 AM
We have some nice document and Video on that.
https://supportforums.cisco.com/docs/DOC-15126
https://supportforums.cisco.com/docs/DOC-14960
thanks.
06-01-2011 07:50 AM
Follow the instructions in the below link:
Cheers,
Steve
--
If this helps you and/or answers your question please mark the question as "answered" and/or rate it, so other users can easily find it.
06-01-2011 07:49 AM
Hi,
Here is the doc that i hv written and this includes the video as well!! this will resolve the issue!!
https://supportforums.cisco.com/docs/DOC-14960
Please dont forget to rate the usefull posts!!
Regards
Surendra
06-01-2011 07:50 AM
We have some nice document and Video on that.
https://supportforums.cisco.com/docs/DOC-15126
https://supportforums.cisco.com/docs/DOC-14960
thanks.
06-01-2011 07:50 AM
Follow the instructions in the below link:
Cheers,
Steve
--
If this helps you and/or answers your question please mark the question as "answered" and/or rate it, so other users can easily find it.
06-01-2011 07:54 AM
thanks Stephen for providing the information. Nice timing
06-01-2011 08:10 AM
Thanks Stephen and Vinay for yours answers. I'm going to test thoses processes;
06-06-2011 12:32 AM
Thanks a lot. I tested it and it ok.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide