10-29-2019 04:33 AM - edited 07-05-2021 11:12 AM
Hi team,
My AP is not seeing 2.4GHz signal but still its both slot working on 5 GHz. Can you please help to resolve issue. Its happening to multiple AP. Can we disable FRA?
Solved! Go to Solution.
10-29-2019 02:34 PM
You can disable FRA by going:
Wireless>Advanced>RF Management> Flexible Radio Assignment> Disable
You then might need to run this CLI command if the APs still do not change the XOR radio to 2.4
config advanced fra revert all auto
If you have manually configured the setting on any of the XOR radios then use this command
config advanced fra revert auto-only auto
10-29-2019 02:46 PM
10-29-2019 02:34 PM
You can disable FRA by going:
Wireless>Advanced>RF Management> Flexible Radio Assignment> Disable
You then might need to run this CLI command if the APs still do not change the XOR radio to 2.4
config advanced fra revert all auto
If you have manually configured the setting on any of the XOR radios then use this command
config advanced fra revert auto-only auto
10-31-2019 03:03 AM
Thanks for the post
11-06-2019 03:19 AM
Can you also please tell me the command to enable FRA To be operated as manual from auto.
11-06-2019 01:04 PM
There isnt a option to enable FRA as manual
What you can do is under Wireless>Accesspoints> Dual-Band Radios
you can configure each AP Radio Role Assignment to manual, then select client serving or monitor and select the band.
11-13-2019 12:31 AM
We did disable FRA and AP is seen with 2.4GHz but still no wlan visible on 2.4Ghz. Any specific reason
11-13-2019 01:17 AM
11-13-2019 06:09 AM
11-13-2019 01:42 PM
11-13-2019 10:39 PM
Hi @Leo Laohoo
Its showing radio role as auto , but also seeing client serving is marked but its graded. I am attaching picture.
11-14-2019 02:32 AM
11-13-2019 03:39 AM
10-29-2019 02:46 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide