I just completed an install of 13 AP's and a WLSE. I have the floor plans in with the locations of the AP's on it. Looks like everything is working, I havent doen teh client walkabout yet, and that may be what needs to be done to answer my question. This is my first WLSE installation, so I am not 100% sure of what needs to be done.
What I have is all the AP's are red. Shouldnt they be green? From what I understand, the WLSE should adjust the power outputs of the radios to prevent interference from each other, is that correct, or is that a different device? I think these are red because of interference, and wonder if the walkabout will resolve it. I am scheduled to do it tomorrow afternoon now that I have the power injectors for the last two AP's, and the VLANs resolved and firewalled.
AP icon color is just to give the user a visual indication telling him that there may be one or more active P1 Fault in the display fault screen on WLSE. You can goto the display fault screen, look at the fualt and determine the corrective action to clear it. The icon would then turn bak to green indication that there are not active faults for that device.
As for the Radio Management, this is the sequence:
- Configure WDS and make sure that the WDS is authenticated with WLSE
- Discover and do the AP Inventory
- Turn on Radio Monitoring on the AP
- Run AP Radio Scan,
- Do Client Walkabout followed by RPG calculation. You can refer to the WLSE docs for more details on this. There is Assisted Site Survey Wizard in Location Manager which you can use to perform all these tasks starting with the radio scan in the correct order.
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 22.214.171.124, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...
Hey Guys,I Have several 1600 Series AP's (AIR-CAP1602I-ZK9) that was working with WLC before, I changed them with 1800 series but would like to use 1600 Access Points series independently and without WLC for somewhere else, so I want to know do they...
This event was scheduled for September 23rd, but it has been moved to November 10 due to complex and unexpected circumstances. We apologize for all the issues this may cause.
Community Live- All Things LTE…4G, 5G and Whatever’s Next
(Live event - formerly...