Wireless

A quick wireless newbie question - I'm trying to sort out the design details using a WiSM. I have a new site and have budgeted a pair of 6513's with WiSM's. There are 9 branch offices that are going to be connected via 2821 routers over CSME and they...

I've got a site with six 1310's installed. Prior to Hurricane Katrina we've had no problems with the setup.Since the hurricane, we've replaced all but two of the units (those two didn't get flooded). On the units that were replaced, we also replaced ...

I am having an issue with a cisco AIR-AP1230B-A-K9 running WDS. I am running Version 12.3(2)JA2. The no space error is posted in the log file. I also receive this error when trying to save the config.Building configuration...% Configuration buffer fu...

We have 1020 access points with a combination of 4402 and 4136 controllers. We can watch the log in the 3750 switch and see them power cycle randomly. This, of course, is causing outages for the users. Has anyone seen this?From our log:May 18 10:38:1...

We are finding that clients are showing up on the map far away from where we know they are. The maps and AP placement were double-checked. Is there anything we can tweak for this?

Hi Sir,I set up a Radius server(Cisco ACS) to authenticate wireless users via 802.1x. The EAP protocol deployed is Microsoft PEAP as most of the clients OS is XP. The users might be sharing the same laptops. When a user select the wireless network to...

HiI have a problem with the Aironet BR350, in the way it handles diversity. I run V12.05, and I use them as bridges with clients which means other bridges can route through.I have Tx/Rx diversity enabled on both rightand left antennae, and I log the ...

I have a brand new 1131AG AP that restarts about every 5-10 minutes consistantly. I have tried different power supplies and different outlets and have tried several different revs of images to no avail. Any ideas on how to troubleshoot this? Thanks.

What would one lose in functionality by running all LAPs in (eventually, hybrid) REAP mode on a local campus network (i.e. all in the same VLAN domain)?Do REAP APs count the same as non-REAP APs in terms of WCS AP capacity (i.e. is it a bandwidth or ...

I cant connect wirelles to the 876w router.I use to test the connection, a laptop with a wireless connection card:Intel(R)PROSet/Wireless 2200BG.My configuration for the radio interface:interface Dot11Radio0 no ip address ! ssid matrix vlan 1 authent...

We have a couple of hundred 1131 series APs we want to convert to lightweight to use with WiSM and WCS, but we're having trouble figuring out how you tell the APs to accept power from the injectors and not fall into the low-power state. We've scoured...

hello,Clients Using WPA/WPA2 and Power Save May Fail to Authenticate.A hidden configure level command, "dot11 wpa handshake timeout", can be used to increase the timeout between sending the WPA key packets from the default value (100 ms) to a value b...

We have two problems, both of which run into what I think are limitations of WCS, and I'd love to hear any advice on how to deal with these.1) We're getting a new campus, which currently consists of one building, but will be expanding in the future. ...