09-08-2015 02:06 AM
Hi ,
Does anybody know if there is an option to restart cisco wap4410n via command line. I couldn't see a command to do this.
09-08-2015 09:25 AM
you have ssh connection to the wap4410n?
test :
rc wlan stop
rc wlan start
on internet only find this procedure:
Step 1. Log in to the web configuration utility page and choose Administration > Reboot. The Reboot page opens:
Step 2. To reboot the device, click the radio button Yes to reboot the access point from its web-based interface.
Step 3. Click Save to save the set up. Rebooting the device will not cause the device to lose any of the stored configuration.
Step 1. Press the Reset button for less than eight seconds with a pin located at the back of the device.
Step 2. The Access Point reboots and is refreshed.
09-08-2015 10:30 AM
Try this commands,
rc wlan stop
ifconfig br0 down
ifconfig br0 hw ether xx:xx:xx:xx:xx:xx
ifconfig br0 up
rc wlan start
Thanks.
09-08-2015 11:17 AM
Hello haneef0011,
Thank you for using the Small Business Support Community!
Unfortunately, the command line interface (CLI) is not a valid configuration method for the WAP4410N and is not supported.
If you have any other questions, please feel free to post them here and I will do my best to help!
Best,
Taylor
09-09-2015 12:00 AM
Thank you for the update Taylor..
Thanks,
Naveen
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide