Due to insufficient inline power on cisco aironet 1700 series AP

[ABPDIGITAL]

Hi, I am getting the below warning notifications on our cisco aironet 1700 series AP. Please let us know how to resolve this.

Due to insufficient inline power. Upgrade inline power source or install power injector.

[Leo Laohoo]

The AP is complaining that it is not getting adequate power source.

[ABPDIGITAL]

Dear Leo,

How can we check whether the AP is getting proper power because we have other AP's connected to same switch on that we are not observing any thing like this.

[Leo Laohoo]

If this is a Cisco Catalyst switch, then post the complete output to the command "sh power inline".

[ABPDIGITAL]

Dear Leo,

Its unmanage sw 

[Leo Laohoo · Accepted solution]

---

@ABPDIGITAL wrote:
Its unmanage sw 

---

Unmanaged switch.  

There is no way to diagnose if the switch still has enough PoE allowance to power up the AP. 

Take out one of the functioning AP.  If the PoE error message stops, then it is a PoE allowance issue.

[MHM Cisco World]

the SW have limit inline power, after some point the SW stop provide the power or provide less than need, 
show power inline <<- in SW give some hint if SW have capacity to provide this AP with power or not.