I just installed a RV260P Router with a 240AC AP in mesh mode with 141 Mesh extender.
I have setup the router with 4 VLANs (#1 left as default).I have set up the AP with 4 WLAN/SSID each mapped to a VLAN. I have left the port on the router for the AP as untagged on VLAN1 and then native VLAN on AP (Primary AP) set to 1.
From either a wired port or the SSID on VLAN1 I can reach the AP setup page, but I cant reach from the other VLANs. (VLAN's are set up for inter-VLAN routing) I can reach other devices. but not the AP setup page.
Any thoughts on what I need to change to allow me to access the AP setup page from other (multiple) WLAN/SSID or VLAN port?
Thanks in advance,
Ron
