% Invalid input detected at '^' marker.

[F5MZE]

Hi there,

Trying to access to the config terminal, I get error 

% Invalid input detected at '^' marker.

Here is my process :

Login to my access point via ssh

login as :admin

Using keyboard-interactive authentication.

Password:xxxxxxxxxxx

AP>enable

Password:xxxxxxxxxx

AP#configure terminal

        ^

% Invalid input detected at '^' marker.

AP#

Any idea ? Thanks for helping

[F5MZE]

config t does not work

[F5MZE · Accepted solution]

Finally find the solution, I have re-created the admin user of the AP from the WLC :

config ap mgmtuser add username <myUser> password <myPassword> enablesecret <myEnablePassword> <myApName>

and now, when I connect to my AP, I can run config terminal

Thanks to all for your help

[guilhermetakeuti]

Please, could you explain how do I reset my admin and password? I have the same problem as yours and I can't do these resets. thanks

[guilhermetakeuti]

I can not do this:
config ap mgmtuser add username <myUser> password <myPassword> enablesecret <myEnablePassword> <myApName>

[Fabian-Gort]

Hi.

i have the same issue, did you figure it out? tried many things but still no luck

[ganbayar-ganzorig]

I have a little bit different situation please help me i was trying to set the basic switch configuration but when i try to set minimum length of password this error shows up 
Switch(config)# no ip domain-lookup
Switch(config)#security passwords min-length 8
                            ^

% Invalid input detected at '^' marker.