Open WAP200

[MartinDSmith]

I have a wap200 and would like to set it to an open network where other people who access it aren't required to enter a username and password? I'm new at this and haven't been able to see how to set that part up and would like to see if anyone could assist?

Thank you

[jeffrrod]

Dear Martin.

Thank you for reaching the Small Business Support Community.

Even though the wireless security authentication is the recommended practice, you can disable the "Security Mode" from the Wireless>Wireless Security tab.  Just in case below is a link to the WAP200 admin guide as a reference;

http://www.cisco.com/en/US/docs/wireless/access_point/csbap/wap200/administration/guide/WAP200_V10_UG_Rev_B_web.pdf

I hope this is what you were looking for and please do not hesitate to reach me back if there is any further assistance I may help you with.

Kind regards,

Jeffrey Rodriguez S. .:|:.:|:.
Cisco Customer Support Engineer

*Please rate the Post so other will know when an answer has been found.