01-14-2013 06:35 AM
Hi,
I am trying to set up SSH/Telnet on a WPA2000 Wireless-G Access Point. I have looked for documentation but am unable to find any that says how to do this via the GUI, and I cannot see any obvious place where this could be. Has anyone manged to set this up? I would prefer SSH but telnet will do.
Solved! Go to Solution.
01-14-2013 07:45 AM
Hi Sarah, the wireless small business products do not support a CLI configuration, hence no documentation. Additionally, the only management options would be through http/https and SNMP V1, 2, 3.
-Tom
Please mark answered for helpful posts
01-14-2013 07:45 AM
Hi Sarah, the wireless small business products do not support a CLI configuration, hence no documentation. Additionally, the only management options would be through http/https and SNMP V1, 2, 3.
-Tom
Please mark answered for helpful posts
01-14-2013 08:08 AM
Thanks Tom.
I was afraid of that. Thanks for the update.
01-14-2013 08:19 AM
If you really want (I don't recommend) you can get WAP4410N. It supports set/get commands. However, this CLI is also unsupported but it is accessible (easily).
I do forewarn, those devices have known stability issues so I would not put weight in a CLI access versus a solid performing product.
-Tom
Please mark answered for helpful posts
01-15-2013 01:34 AM
Hi Tom,
We're going to stick with the WAP2000's we have. The reason for me trying to access the CLI is that the firmware has been updated to 2.0.0.5 and the device is no longer accessible over HTTP and the wifi no longer works. The wireless light is on however.
Sarah
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide