Hello,
i am struggling to set up an ACL inside the GUI of my 140AC access point.
How is this meant to work ? If i have more than one rule, are they processed from top to the bottom ? If so, how can i change the order of the rules after implementing them ? I saw i can move them via drag&drop, but after saving/updating the ACL the order is the same as before. So is the order only dependent on the order i typed in the rules ? (cant be !)
I also recognized that rules work for complete networks (i.e source IP 192.168.33.0/255.255.255.0 to destination IP 192.168.33.0/255.255.255.0), but not for a single host (i.e source IP 192.168.33.0/255.255.255.0 to destination IP 192.168.33.100/255.255.255.255). Do i do something wrong ?
Any help is appreciated. Thanks in advance.
