Suggestion for next/last firmware release of WRVS4400N v2

[RobertHessenauer]

Since this router already set up for IPv6 and Dual-Stack traffic, would it be possible to give it the ability to get its IPv6 prefix from the WAN side of the router.

Example:

I have Comcast, and as long as my modem and router support IPv6, with the router also supporting DHCPv6-PD to get the /64 prefix from comcast.

I now have an RV180W so this is not an issue for me, but my father is inheriting the WRVS4400N from me and he is also on Comcast.

Thanks

Robert Hessenauer

[juan_diego_rodriguez]

Hello Mr. Hessenauer,

On this case I recommend you to install the latest firmware available for this device (2.0.1.3)

Let me send you the link from the cisco site where you could download it.

http://www.cisco.com/cisco/software/release.html?mdfid=282414016&softwareid=282487380&release=2.0.1.3&relind=available&rellifecycle=&reltype=latest

If this answer was satisfactory for you, please mark the question as Answered.

Diego Rodriguez

Cisco network engineer

Thank you