cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
763
Views
0
Helpful
2
Replies

WAP 4400N

Y@n94
Beginner
Beginner

Hello
I have more than 10 WAP 4400N the problems I meet the most
1-the wifi signal is good but no one can connect this AP refuses any connection saying that the « password is incorrect » when I disconnect the ethernet cable (POE) and I connect after a second everyone arrives at this connects for a few minutes and the moment after the same scenariot recurs.
2-the second problem is that some phone and computer arrive at this connection and other cons "impossible to have an IP address" message that is displayed after an attempt to connect to the AP 

please help me to resolve this is problem  

1 Accepted Solution

Accepted Solutions

The first thing is to check the DHCP address scope usage.

 

Seconds capture some logs from the command line and post the information here.

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post

2 Replies 2

The first thing is to check the DHCP address scope usage.

 

Seconds capture some logs from the command line and post the information here.

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

hi

thank you for your intervention and excuse me for my late

 

please  can i have the cli of this AP and capture

 

cordialy

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: