WAP121 Workgroup Bridge mode

[KukuRuku320]

Hi,

I have an old computer with dead wifi nc and I thought that bridging it with was121 should work, but can't find anywhere any comprehensive documentation on how to set it up. Any help,please?

Thanks

[Clayton Sill]

Hello Risa,

     Not sure what you are trying to accomplish here. You would use the Workgroup bridge mode to Bridge the WAP121 to another wireless device like a Wireless router or a Access Point to extend your wired network.

If you want some documentation though go to this link below.

http://www.cisco.com/en/US/docs/wireless/access_point/csbap/wap121/administration/guide/WAP121_321_AG_en.pdf

Hope this helps,

Thanks,

Clayton Sill

[naarjuna]

Hi Risa,

I can provide you an article that explains how to configure the work group bridge and all its details.

Refer article Configure Work Group Bridge on WAP121 and WAP321 Access Points

I hope this helps,

Thanks,

Naresh Arjunan

Please rate useful posts.