cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1845
Views
0
Helpful
4
Replies

WAP200, signal disappearing

McRemic64
Level 1
Level 1

Hello guys,

first of all, I must precise that I am French and that my english is not perfect. I hope you will undesrtand what i say

I bought a Cisco WAP200 two years ago and I am encountering a problem since then.

Every hour or so, the Wi-Fi signal seems to disappear. I mean that every device connected lose connection simultaneously.

I have checked some parameters but didn't find the source of the problem.

The AP was on firmware 2.0.2.4. I decided to upgrade it to 2.0.4.0, and it got worse ! Now i'm losing the signal every 20 minutes.

For some reason, I can't upgrade it to 2.0.6. I have a blank page, nothing happens.

I precise that it is just the signal vanishing, i can still access to the AP management page with a computer on ethernet. So the WAP200 does not reboot on is own.

Here is what i tried to do :

- change the wireless network mode

- key renewal timeout set to 86400

- power output decreased to 25%

I also tried to reset the WAP200 to factory settings and load a setup from file or re-do it from scratch without success.

I have been searching for days but couldn't find anything that could solve my problem.

I'm looking forward your experience to help me

4 Replies 4