1200 Series Access Point Memory

[BATCCOLOGIN]

Does anyone know what the maxiumum amount of RAM that can be fitted in a 1200 series AP?

The default is 16MB but just getting the device up and running uses about 65% of that with my current config. When 12 to clients associate running TKIP the memory utilisation threshold break 75%.

I am expecting an upturn in use over th enext few months and I want to head off any performance problems due to memory exhaustion.

Any ideas? I'm busy trawling the site at the moment....

Thanks,

DH

[#2]

I would suggest you to upgrade the 1200 Access Point memory to 64 Mb. This should be sufficient for most scenarios.

[o-ziltener]

Hello

I dont think that there is an option for more memory in the future...

best regards

Oliver