1300 Bridge association

[deanyoung]

I have a pair of 1310 Bridges set up in a point-to-point environment. The problem I picked up is when my root goes down after a power failure, the non-root does not associate again until I power it down and up again.

Is there a setting to tell the non-root to keep trying till the association is back again?

The settings on both bridges are:

station-role install root

station-role install non-root

[m.singer]

The install mode is required initially till the antennas are aligned. After that you can change the modes to root and non-root bridge. Try doing this change. it will work as expected.