Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Hi,For some reason I can not access the 340 bridge through the console cable. I'm using a straight through cable and my hyperterminal settings are 9600,8,none,1,xon/xoff and I can not get the menu. If I connect to another 340, this still does not wor...
How do you enable or start using RTS/CTS. The layout of my network is long hallways with rooms on either side with AP's in hall and Nodes in the rooms off the hallway. I am sure I am running into the Hidden node problem but don't know how to enable m...
i upgraded with the cac tool and was able to get back to it thru the console and the http but the radio will not enablemessage in event log is Interface Dot11Radio0, failed - cmd busy any ideas? Mike Emenaker valley view hospital [email protected]
Has anyone successfully managed to get a WDS AP to authenticate with this box either using the box's internal AAA or an external ACS or AP local radius server?
I am struggling with an AP1200 install ... clients associating with the AP cannot obtain their IP addresses via DHCP.I have not been able to discover how to config AP to provide DHCP services. The AP is connected to a PIX firewall via ethernet, the P...
I have user who is getting these error messages from the Cisco VPN client version 4.6. Does anyone know what the possible problems might be.1 17:13:30.617 08/03/05 Sev=Warning/2 CVPND/0xE3400014The VPN Client could not find the adapters GUID - Virtua...
Hi,I've been working with Cisco 1310 bridges and 1231 APs. So far, I have used the browser to configure the bridges. I'm wondering is there a need to know the IOS commands to configure them. Does the IOS give more features to configure?. Or knowing I...
Dear friends,Our Access point is having a throughput of 54 Mbps.First of all I just want to know this bandwidth is shared or dedicated.Second thing some wireless users are having 54Mbps wireless card and some are having 11 Mbps card but practically o...
Is this device capable of Point-to-Multipoint connectiosn with the 802.11a radio? If so, how many bridges can it do?
HI everyone..Ok heres the scenario..I've setup an AP as a local radius server and I can get all my infrastructure APs to authenticate with it.. however I cannot get the WDS to authenticate with the WLSE.. see below outputs..WIG-ap03#sh wlccp wnm sWNM...
I'm using Aironet 1100 AP, with LEAP authentication and using ACS v3.3 as radius server. I created VLAN 1 set as native vlan (for management vlan), VLAN 25 (for guest users) and VLAN 50 (for my internal users). I have two (2) internal users leap auth...
Hi, Not sure anyone facing this problem. I have purchased a WLSE recently for the purpose of detecting the Rouge AP. I felt that WLSE did not perform to the standard I want. I have found a long list of Rouge but it only 3 out of 100 show the location...
hey guys,I have to setup a wireless network to support three wireless networks, voip, admin and public. Voip ips are 172.16.x.x/24 and admin ips are 10.100.x.x/24. public is a full class C routable ip set.I was thinking I could secure it by1. each ne...
I have a tower building 6 stories high and all floors are almost the exact same dimensions across. I used to have cisco 350 cards until a rececnt swap out of all notetbooks across the facility. When this happened we installed new machines with tri-mo...
