1524 LAP with 2.4, 4.9 and 5.8 radios. The WLC configuration is setup to allow client access via the backhaul interface. There's a need to be able to access from 4.9 and 5.8 clients. 4.9 clients work fine as do the 2.4 clients. The 5.8 is used for Mesh (RAP/MAP) though a need has arisen to allow client access via the 5.8 radio. The WLC has been configured to allow client access through the mesh/backhaul wireless interface though it doesn't work.
Is client access through the 5.8 interface possible or would we have to install a second 5.8 interface?
Table of Contents
Table of ContentsOverviewConnecting a Catalyst 9800 WLC to Cisco DNA Center ManuallyConnecting an AireOS WLC to Cisco DNA Center ManuallyCisco DNA Center Assurance Deployment Guide References
The purpose of this document...
Securing devices without 802.1X
PSK (Pre-Shared-Key) WLAN is widely used for consumer & enterprise IoT onboarding as most of IoT device doesn’t support 802.1X. While PSK WLAN provides an easy way to onboard IoT, it also introduces challenges as...
Due to the certificate expiration, any new Control and Provisioning of Wireless Access Points (CAPWAP) or Light Weight Access Point Protocol (LWAPP) connection will fail to establish. The main feature that is affected will be the Acce...
Where to download
Attached files on this post
Alternatively, cloud version (only summaries)
New implementation for the WLC Config Analyzer. it is a new re-write of the application, with clean up and improved checks
Support for IOS...